HIGHLY LIQUID UMR2 사용자 설명서 - 페이지 6

{카테고리_이름} HIGHLY LIQUID UMR2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIGHLY LIQUID UMR2 11 페이지.

Highly Liquid

UMR2 RevC / V1.0

3.2.3 PRGM and MODE Switch Wiring

A PRGM switch is used during the UMR2 setup procedure and during firmware updates. Wire any

momentary or latching switch (not included) as shown.

A MODE switch is used to select the UMR2 mode of operation. Wire any latching switch (not included)

as shown.

If desired, remote STBY and ACT LEDs can be attached to the UMR2 as shown below. Current limiting

resistors (typical value of 1kΩ is shown) must limit LED current to 10mA or less.

Page 6 / 11