Brother Stampcreator PRO SC2000USB Referensi Cepat - Halaman 12
Jelajahi secara online atau unduh pdf Referensi Cepat untuk Pembuat label Brother Stampcreator PRO SC2000USB. Brother Stampcreator PRO SC2000USB 36 halaman.
Halaman Cetak
Connecting the Interface and Power Supply Cables
After connecting the interface and power supply cables to the SC-2000USB, it can be used to create stamps from any
layout that you design in the P-touch Editor software or Stampcreator Express software installed on your computer.
a Be sure both the SC-2000USB and the computer are turned off.
b Attach the appropriate interface cable connector to the computer port specified in the table below.
P-touch Editor software
Ver. 4.2 for Windows
☞ After connecting the 9-pin connector, be sure to tighten the screws to lock it into place.
c Connect the other end of the interface cable to the interface port on the back of the SC-2000USB.
d Insert one end of the power supply cord into the power supply port on the SC-2000USB and the other end of the cord
into an AC outlet.
e Flip the power switch on the right side of the SC-2000USB to " | ", and then turn on the computer. The message
"READY" appears on the LCD display of the SC-2000USB when it is ready to begin engraving stamps.
9-pin connector
8-pin connector
USB connector
Power switch
®
®
Windows
XP / Windows Vista
Power supply port
Back:
8-pin connector
Operating system
®
/ Windows
USB connector port
8-pin connector port
Computer port
®
7
USB port or Serial port (9 pin)
USB connector
9