- ページ 12

ラベルメーカー Brother Stampcreator PRO SC2000USBのPDF クイック・リファレンスをオンラインで閲覧またはダウンロードできます。Brother Stampcreator PRO SC2000USB 36 ページ。

Connecting the Interface and Power Supply Cables

After connecting the interface and power supply cables to the SC-2000USB, it can be used to create stamps from any

layout that you design in the P-touch Editor software or Stampcreator Express software installed on your computer.

a Be sure both the SC-2000USB and the computer are turned off.

b Attach the appropriate interface cable connector to the computer port specified in the table below.

P-touch Editor software

Ver. 4.2 for Windows

☞ After connecting the 9-pin connector, be sure to tighten the screws to lock it into place.

c Connect the other end of the interface cable to the interface port on the back of the SC-2000USB.

d Insert one end of the power supply cord into the power supply port on the SC-2000USB and the other end of the cord

into an AC outlet.

e Flip the power switch on the right side of the SC-2000USB to " | ", and then turn on the computer. The message

"READY" appears on the LCD display of the SC-2000USB when it is ready to begin engraving stamps.

9-pin connector

8-pin connector

USB connector

Power switch

Windows

XP / Windows Vista

Power supply port

Back:

8-pin connector

Operating system

/ Windows

USB connector port

8-pin connector port

Computer port

USB port or Serial port (9 pin)

USB connector