Brother Stampcreator PRO SC2000USB Snelle referentie - Pagina 12
Blader online of download pdf Snelle referentie voor {categorie_naam} Brother Stampcreator PRO SC2000USB. Brother Stampcreator PRO SC2000USB 36 pagina's.
Pagina afdrukken
Connecting the Interface and Power Supply Cables
After connecting the interface and power supply cables to the SC-2000USB, it can be used to create stamps from any
layout that you design in the P-touch Editor software or Stampcreator Express software installed on your computer.
a Be sure both the SC-2000USB and the computer are turned off.
b Attach the appropriate interface cable connector to the computer port specified in the table below.
P-touch Editor software
Ver. 4.2 for Windows
☞ After connecting the 9-pin connector, be sure to tighten the screws to lock it into place.
c Connect the other end of the interface cable to the interface port on the back of the SC-2000USB.
d Insert one end of the power supply cord into the power supply port on the SC-2000USB and the other end of the cord
into an AC outlet.
e Flip the power switch on the right side of the SC-2000USB to " | ", and then turn on the computer. The message
"READY" appears on the LCD display of the SC-2000USB when it is ready to begin engraving stamps.
9-pin connector
8-pin connector
USB connector
Power switch
®
®
Windows
XP / Windows Vista
Power supply port
Back:
8-pin connector
Operating system
®
/ Windows
USB connector port
8-pin connector port
Computer port
®
7
USB port or Serial port (9 pin)
USB connector
9