Fujitsu ETERNUS DX Disk Panduan Konfigurasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 halaman. Server connection, fcoe for linux driver settings for converged network adapter cards
Juga untuk Fujitsu ETERNUS DX Disk: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (44 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (29 halaman), Panduan Konfigurasi (25 halaman), Panduan Konfigurasi (32 halaman), Panduan Konfigurasi (31 halaman), Panduan Konfigurasi (43 halaman), Panduan Konfigurasi (21 halaman), Panduan Konfigurasi (24 halaman)

Halaman Cetak

Fujitsu ETERNUS DX Disk Panduan Konfigurasi

Chapter 1

Setup Procedure for Emulex Converged Network Adapter Cards

1.2

Setting Up the Converged Network Adapter Cards

Enter the number of the Converged Network Adapter card that is to be checked and press the [Enter]

key.

Example:

-------------------------------------------------------------------------------

You Will be prompted to reboot for all changes to take effect.

1. OCe10102-F:

2. OCe10102-F:

-------------------------------------------------------------------------------

==> Select 1

Check the [Mem Base] and [Port Name] values.

The value of [Mem Base] is the physical address and the value of [Port Name] is the Converged Net-

work Adapter card WWN.

Example:

-------------------------------------------------------------------------------

01:

Mem Base:

Port Name:

Vlan ID:

-------------------------------------------------------------------------------

===>

Record the physical address and WWN in the "WWN instance management table for the server".

Refer to

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Emulex OneConnect FCoE BIOS Utility, xxxxxxxx

This utility displays and saves changes when selected.

Emulex Adapter in the System:

Bus:03 Dev:00 Func:02

Bus:03 Dev:00 Func:03

Enter <Esc> to exit

<↑/↓> to Highlight, <Enter> to Select

Emulex OneConnect FCoE BIOS Utility, XB4.01a0

OCe10102-F:

CD4C0000

Firmware Version:

10000000C9D043DD

1002

DCBX mode:

CEE mode

Enable/Disable Boot from SAN

Scan for Target Devices

Reset Adapter Default

Configure Boot Devices

Configure DCBX mode

Configure FCF CEE Parameters

Configure FCF CIN Parameters

Configure Advanced Adapter Parameters

Enter <Esc> to Previous Menu

< / > to Highlight, <Enter> to Select

"Appendix A WWN Instance Management Table for the Server (Blank)" (page

WWPN:

10000000C9D043DD

WWPN:

10000000C9D043DF

<PageDn> to Next Page

Bus#: 03 Dev#: 00 Func#: 02

2.702.200.28

BIOS: Disabled!

Node Name:

20000000C9D043DD

33).

ESX

P3AM-4772-11ENZ0