Fujitsu ScanSnap iX500 Panduan Memulai - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Pemindai Fujitsu ScanSnap iX500. Fujitsu ScanSnap iX500 16 halaman. Windows
Juga untuk Fujitsu ScanSnap iX500: Panduan Memulai (17 halaman), Panduan Pengaturan Cepat (3 halaman), Memulai (18 halaman), Tindakan Pencegahan Keselamatan (11 halaman), Manual (2 halaman), Panduan Memulai Cepat (2 halaman), Manual Koneksi Wi-Fi (41 halaman)

Open the ADF paper chute (cover) of the ScanSnap.

The ScanSnap is powered on and the [Scan] button lights

in blue.

ATTENTION

The bottom of the ScanSnap may become hot when the

ScanSnap is used, but this heat does not affect operation

or cause any physical harm. However, be careful not to

drop the ScanSnap when carrying it.

When the ScanSnap is turned on and left unused for 4

hours, it will turn itself off automatically. To turn the

ScanSnap back on, perform one of the following

operations:

- Press the [Scan] button (Scanning does not start).

- Close the ADF paper chute (cover) and open it again

The time until power-off can be changed. For details, refer

to the Operator's Guide.

HINT

When you close the ADF paper chute (cover), the

ScanSnap will turn off.

Check the ScanSnap Manager icon.

The ScanSnap Manager icon

appears when you click

right of the taskbar.

To have the ScanSnap Manager icon

notification area, drag the icon and drop it onto the notification

area.

ATTENTION

If the ScanSnap Manager icon is

menu. You can reference the appropriate actions for connecting the scanner.

The ScanSnap Manager icon

ATTENTION

If the ScanSnap Manager icon is

[To establish connection] from the menu. You can reference the appropriate actions for connecting

the scanner.

is displayed in the menu that

on the notification area, at the far

always displayed on the

, right-click on

appears in the Dock.

, while holding down the [control] key, click

ADF Paper Chute (cover)

[Scan] Button

and select [To establish connection] from the

and then select