Indesit LFT 114 UK Panduan Servis - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Servis untuk Mesin pencuci piring Indesit LFT 114 UK. Indesit LFT 114 UK 26 halaman. Platform eos. built in

Halaman Cetak

CHAPTER 5: COMPONENTS

The Base:

The base is in plastic and contains all the functional-parts of the dishwasher as well as acting as support for the wash-basin.

Built-in dishwashers are provided with three legs that are for the purpose of levelling out the machine: two are on the fore-front

and one at the back in the middle of the machine which is equipped with an adjustable-nut.

One of the advantages provided by the new type of base is that it facilitates access to the motor-room from the front-door

opening via two locking-hooks.

The small Basin placed under the dishwasher, may be removed by unfastening further two hooks and extracting it towards the

front part of the machine.

NB: Should the hooks that lock the front-door of the base or the basin be damaged, the base has been equipped with

self-rivetting screws, which will seal the components well and so avoid having to replace the entire base.

Adjustable Legs:

Three legs serve to adjust the height of the machine and to level it out horizontally. The front-panels must be adjusted directly by

the leg. The back-leg of the dishwasher may be adjusted by means of a hexagonal screw placed in the middle front part of the

machine, under the connecting Hardware-key hole.

"Synchro-Motorpump":

Introduced on machines in the low range. Available in two versions: one on LVS for U.K.(that works with 220/240 volts); and the

second for the Italian market and the rest of the world. (tnsion between 220/230 volts).

Muff or Junction

On low-range machines, the alternate-washing motor has not been envisaged, but simply a water-distributer which supplies the

water to both syphons simultaneously.

Water Heater:

The water-heater has been mounted on the Archimedian water-pump.To disconnect or replace the water-heater, one needs only

to rotate the Water-heater/motor in an anti-clockwise direction and to pull it out.

The "O-Ring" seves to prevent any water-leakages from taking place; so care must be taken when fixing it back into place again

and it must often be checked for water-leakages.

Airbreak:

The Airbreak is placed on the left-hand side of the machine and its functions are:

1.To prevent the water from going back into the water-supply system once it has entered the machine.

2.Airbreak (venthole)

3.To allow at least 3% unsweentened water to be introduced which will prevent excessive formation of foam.

4.To contain the Turbine Litre-count

As compared to the former one, this Airbreak does not store any water. It must be remembered that the regeneration-cycle of the

resines on this model, differs to the previous one.

Service Manual

Manual LFT 114 - 116 - 216

Edition

2007.10.15

Language

English