Dell POWEREDGE 4300 Panduan Instalasi - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Dell POWEREDGE 4300. Dell POWEREDGE 4300 28 halaman. System board upgrade
Juga untuk Dell POWEREDGE 4300: Informasi Instalasi (6 halaman), Pemasangan Rak (37 halaman), Panduan Instalasi Upgrade (14 halaman), Pemasangan Rak (34 halaman), Panduan Peningkatan (23 halaman), Panduan Peningkatan (24 halaman), Panduan Petunjuk Instalasi (12 halaman), Manual Penggantian (3 halaman), Informasi Instalasi (6 halaman), Panduan Instalasi (14 halaman)

Halaman Cetak
Dell POWEREDGE 4300 Panduan Instalasi
support.dell.com
To replace the 24-U rack's front and back doors, perform the following steps:
1.
Lift the front door into position, and align the hinges with the hinge insert in the
rack as shown in Figure 1-4.
2.
Slide the hinge pins into the hinge insert in the rack until the hinges lock into
position.
3.
Repeat steps 1 and 2 to install the back door.

Installing the Rubber Feet

To install the rubber feet on the system base, perform these steps:
1.
Lay the system on its left side (see Figure 1-11) on a piece of foam or cardboard
(to prevent damage to the system).
2.
Attach a rubber foot in each of the four corners on the cabinet base (the cabinet's
right side in the former rack configuration) using an 8-32 x 0.5-inch hex-head,
thread-forming screw (screws and rubber feet at provided with the kit), as shown
in Figure 1-11.

Figure 1-11. Installing the Rubber Feet

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide
8-32 x 0.5-inch screw
rubber feet (4)
1-13