Dell POWEREDGE 4300 Installatiehandleiding - Pagina 19

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell POWEREDGE 4300. Dell POWEREDGE 4300 28 pagina's. System board upgrade
Ook voor Dell POWEREDGE 4300: Installatie-informatie (6 pagina's), Installatie rek (37 pagina's), Upgrade installatiehandleiding (14 pagina's), Installatie rek (34 pagina's), Upgrade handleiding (23 pagina's), Upgrade handleiding (24 pagina's), Handleiding voor installatie-instructies (12 pagina's), Vervangingshandleiding (3 pagina's), Installatie-informatie (6 pagina's), Installatiehandleiding (14 pagina's)

Pagina afdrukken
Dell POWEREDGE 4300 Installatiehandleiding
support.dell.com
To replace the 24-U rack's front and back doors, perform the following steps:
1.
Lift the front door into position, and align the hinges with the hinge insert in the
rack as shown in Figure 1-4.
2.
Slide the hinge pins into the hinge insert in the rack until the hinges lock into
position.
3.
Repeat steps 1 and 2 to install the back door.

Installing the Rubber Feet

To install the rubber feet on the system base, perform these steps:
1.
Lay the system on its left side (see Figure 1-11) on a piece of foam or cardboard
(to prevent damage to the system).
2.
Attach a rubber foot in each of the four corners on the cabinet base (the cabinet's
right side in the former rack configuration) using an 8-32 x 0.5-inch hex-head,
thread-forming screw (screws and rubber feet at provided with the kit), as shown
in Figure 1-11.

Figure 1-11. Installing the Rubber Feet

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide
8-32 x 0.5-inch screw
rubber feet (4)
1-13