Dell POWEREDGE 4300 설치 매뉴얼 - 페이지 19

{카테고리_이름} Dell POWEREDGE 4300에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell POWEREDGE 4300 28 페이지. System board upgrade
Dell POWEREDGE 4300에 대해서도 마찬가지입니다: 설치 정보 (6 페이지), 랙 설치 (37 페이지), 업그레이드 설치 매뉴얼 (14 페이지), 랙 설치 (34 페이지), 업그레이드 매뉴얼 (23 페이지), 업그레이드 매뉴얼 (24 페이지), 설치 지침 매뉴얼 (12 페이지), 교체 매뉴얼 (3 페이지), 설치 정보 (6 페이지), 설치 매뉴얼 (14 페이지)

페이지 인쇄
Dell POWEREDGE 4300 설치 매뉴얼
support.dell.com
To replace the 24-U rack's front and back doors, perform the following steps:
1.
Lift the front door into position, and align the hinges with the hinge insert in the
rack as shown in Figure 1-4.
2.
Slide the hinge pins into the hinge insert in the rack until the hinges lock into
position.
3.
Repeat steps 1 and 2 to install the back door.

Installing the Rubber Feet

To install the rubber feet on the system base, perform these steps:
1.
Lay the system on its left side (see Figure 1-11) on a piece of foam or cardboard
(to prevent damage to the system).
2.
Attach a rubber foot in each of the four corners on the cabinet base (the cabinet's
right side in the former rack configuration) using an 8-32 x 0.5-inch hex-head,
thread-forming screw (screws and rubber feet at provided with the kit), as shown
in Figure 1-11.

Figure 1-11. Installing the Rubber Feet

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide
8-32 x 0.5-inch screw
rubber feet (4)
1-13