Dell POWEREDGE 4300 Informasi Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Informasi Instalasi untuk Server Dell POWEREDGE 4300. Dell POWEREDGE 4300 6 halaman. System board upgrade
Juga untuk Dell POWEREDGE 4300: Informasi Instalasi (6 halaman), Panduan Instalasi (28 halaman), Pemasangan Rak (37 halaman), Panduan Instalasi Upgrade (14 halaman), Pemasangan Rak (34 halaman), Panduan Peningkatan (23 halaman), Panduan Peningkatan (24 halaman), Panduan Petunjuk Instalasi (12 halaman), Manual Penggantian (3 halaman), Panduan Instalasi (14 halaman)

Halaman Cetak
Dell POWEREDGE 4300 Informasi Instalasi
2.
3.
&RQYHUWLQJWKH'ULYH&DUULHUV
You can use only 1-inch hard-disk drives with the 1 x 2 backplane. If you have 1.6-inch
hard-disk drive carriers that you want to use with your 1 x 2 backplane, you need to
place 1-inch hard-disk drives in the carrier and modify the 1.6-inch carriers to be 1 inch
in width. To modify the 1.6-inch carriers to 1-inch width, remove the spacer insert.
NOTE: To remove the spacer insert, use a screwdriver to pry open the clips on the
inside of the carrier release handle, and pull the spacer insert away from the carrier.
After you have installed your 1 x 2 backplane, see “Installing and Removing SCSI
Hard-Disk Drives” in Chapter 10 of the Installation and Troubleshooting Guide for
information on how to install your hard-disk drives.
NOTE: The 1 x 2 backplane sets the top drive to SCSI ID0 and the bottom drive to
SCSI ID1.
6
Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information
All manuals and user guides at all-guides.com
On the end with two connectors:
a.
Attach the connector at the end of the cable to the bottom drive connector
on the 1 x 2 backplane.
b.
Attach the second connector to the top drive connector on the 1 x 2
backplane.
Attach the end with one connector to a SCSI controller on the system board.