Dell POWEREDGE 4300 Installatie-informatie - Pagina 6

Blader online of download pdf Installatie-informatie voor {categorie_naam} Dell POWEREDGE 4300. Dell POWEREDGE 4300 6 pagina's. System board upgrade
Ook voor Dell POWEREDGE 4300: Installatie-informatie (6 pagina's), Installatiehandleiding (28 pagina's), Installatie rek (37 pagina's), Upgrade installatiehandleiding (14 pagina's), Installatie rek (34 pagina's), Upgrade handleiding (23 pagina's), Upgrade handleiding (24 pagina's), Handleiding voor installatie-instructies (12 pagina's), Vervangingshandleiding (3 pagina's), Installatiehandleiding (14 pagina's)

&RQYHUWLQJWKH'ULYH&DUULHUV

You can use only 1-inch hard-disk drives with the 1 x 2 backplane. If you have 1.6-inch

hard-disk drive carriers that you want to use with your 1 x 2 backplane, you need to

place 1-inch hard-disk drives in the carrier and modify the 1.6-inch carriers to be 1 inch

in width. To modify the 1.6-inch carriers to 1-inch width, remove the spacer insert.

NOTE: To remove the spacer insert, use a screwdriver to pry open the clips on the

inside of the carrier release handle, and pull the spacer insert away from the carrier.

After you have installed your 1 x 2 backplane, see Installing and Removing SCSI

Hard-Disk Drives in Chapter 10 of the Installation and Troubleshooting Guide for

information on how to install your hard-disk drives.

NOTE: The 1 x 2 backplane sets the top drive to SCSI ID0 and the bottom drive to

SCSI ID1.

Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information

All manuals and user guides at all-guides.com

On the end with two connectors:

Attach the connector at the end of the cable to the bottom drive connector

on the 1 x 2 backplane.

Attach the second connector to the top drive connector on the 1 x 2

backplane.

Attach the end with one connector to a SCSI controller on the system board.