Dell POWEREDGE 4300 설치 정보 - 페이지 6

{카테고리_이름} Dell POWEREDGE 4300에 대한 설치 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell POWEREDGE 4300 6 페이지. System board upgrade
Dell POWEREDGE 4300에 대해서도 마찬가지입니다: 설치 정보 (6 페이지), 설치 매뉴얼 (28 페이지), 랙 설치 (37 페이지), 업그레이드 설치 매뉴얼 (14 페이지), 랙 설치 (34 페이지), 업그레이드 매뉴얼 (23 페이지), 업그레이드 매뉴얼 (24 페이지), 설치 지침 매뉴얼 (12 페이지), 교체 매뉴얼 (3 페이지), 설치 매뉴얼 (14 페이지)

&RQYHUWLQJWKH'ULYH&DUULHUV

You can use only 1-inch hard-disk drives with the 1 x 2 backplane. If you have 1.6-inch

hard-disk drive carriers that you want to use with your 1 x 2 backplane, you need to

place 1-inch hard-disk drives in the carrier and modify the 1.6-inch carriers to be 1 inch

in width. To modify the 1.6-inch carriers to 1-inch width, remove the spacer insert.

NOTE: To remove the spacer insert, use a screwdriver to pry open the clips on the

inside of the carrier release handle, and pull the spacer insert away from the carrier.

After you have installed your 1 x 2 backplane, see Installing and Removing SCSI

Hard-Disk Drives in Chapter 10 of the Installation and Troubleshooting Guide for

information on how to install your hard-disk drives.

NOTE: The 1 x 2 backplane sets the top drive to SCSI ID0 and the bottom drive to

SCSI ID1.

Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information

All manuals and user guides at all-guides.com

On the end with two connectors:

Attach the connector at the end of the cable to the bottom drive connector

on the 1 x 2 backplane.

Attach the second connector to the top drive connector on the 1 x 2

backplane.

Attach the end with one connector to a SCSI controller on the system board.