Dell EMC Integrated Data Protection Appliance DP4400 Panduan Pemasangan Perangkat Keras - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Penyimpanan Dell EMC Integrated Data Protection Appliance DP4400. Dell EMC Integrated Data Protection Appliance DP4400 18 halaman. Emc integrated data protection appliance
Halaman Cetak
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
Hardware Installation Guide
Install the system in the cabinet
Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide
8
Figure 3 Installing screws
WARNING
The system is heavy and should be installed in a cabinet by two people. To avoid
personal injury and/or damage to the equipment, do not attempt to install the
system in a cabinet without a mechanical lift and/or help from another person.
Procedure
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock
into place.
Figure 4 Pull the inner rails out of the cabinet
2. Locate the rear rail standoff on each side of the system. Position the system
above the rails and lower the rear rail standoffs into the rear J-slots on the slide
assemblies.