Dell PowerVault DR4100 Panduan Praktik Terbaik - Halaman 28

Jelajahi secara online atau unduh pdf Panduan Praktik Terbaik untuk Penyimpanan Dell PowerVault DR4100. Dell PowerVault DR4100 41 halaman. Backup and recovery appliance
Juga untuk Dell PowerVault DR4100: Panduan Memulai (10 halaman), Manual (37 halaman), Catatan Rilis (16 halaman), Manual (12 halaman), Manual (24 halaman), Manual (23 halaman), Qiuck Setup (1 halaman), Manual (27 halaman), Manual (25 halaman)

Halaman Cetak
Dell PowerVault DR4100 Panduan Praktik Terbaik
1.
Set bond0 to 1GB using the following command:
network --factory_reset [--auto_bonding_speed <1G|10G>]
administrator@DR1 > network -- factory_reset –auto_bonding_speed 1G
Warning: This will stop all system operation and will reset the network configuration to
factory settings and will require a system robbon. Existing configuration will be lost.
One or more of these interfaces 'eth0,eth1' are in use by an application.
Factory reset cannot be done while interfaces are in use by an application.
Factory reset will remove all application interface settings.
Password required to proceed. Please enter the administrator password :
administrator@DR1 > System --reboot
2.
Use the following command to view the new configuration:
network --show
administrator@DR1 > network -- show
Automatic bonding speed: 1G
Device
Enabled
Link
Boot protocol
IP Addr
Netmask
Gateway
MAC Addr
MTU
Bonding options
Member Interfaces
eth0 MAC
eth0 Max Speed
eth0 Speed
eth0 Duplex
eth1 MAC
eth1 Max Speed
eth1 Speed
eth1 Duplex
3.
Create a bond for the 2x 10GB interfaces using the following command:
28
DR4100 Best Practice Guide | April 2014
Example
Example
: bond0
: yes
: yes
: dhcp
: 10.250.242.173
: 255.255.252.0
: 10.250.240.1
: BC:30:5B:F3:22:74
: 9000
: "mode=balance-alb miimon=100 xmit_hash_policy=2"
: eth0,eth1
: BC:30:5B:F3:22:74
:1000baseT/Full
:1000Mb/s
:Full
: BC:30:5B:F3:22:75
:1000baseT/Full
:1000Mb/s
:Full