Dell PowerVault DR4100 Руководство по лучшей практике - Страница 28

Просмотреть онлайн или скачать pdf Руководство по лучшей практике для Хранение Dell PowerVault DR4100. Dell PowerVault DR4100 41 страница. Backup and recovery appliance
Также для Dell PowerVault DR4100: Руководство по началу работы (10 страниц), Руководство (37 страниц), Примечание к выпуску (16 страниц), Руководство (12 страниц), Руководство (24 страниц), Руководство (23 страниц), Настройка Qiuck (1 страниц), Руководство (27 страниц), Руководство (25 страниц)

Печатать страницу
Dell PowerVault DR4100 Руководство по лучшей практике
1.
Set bond0 to 1GB using the following command:
network --factory_reset [--auto_bonding_speed <1G|10G>]
administrator@DR1 > network -- factory_reset –auto_bonding_speed 1G
Warning: This will stop all system operation and will reset the network configuration to
factory settings and will require a system robbon. Existing configuration will be lost.
One or more of these interfaces 'eth0,eth1' are in use by an application.
Factory reset cannot be done while interfaces are in use by an application.
Factory reset will remove all application interface settings.
Password required to proceed. Please enter the administrator password :
administrator@DR1 > System --reboot
2.
Use the following command to view the new configuration:
network --show
administrator@DR1 > network -- show
Automatic bonding speed: 1G
Device
Enabled
Link
Boot protocol
IP Addr
Netmask
Gateway
MAC Addr
MTU
Bonding options
Member Interfaces
eth0 MAC
eth0 Max Speed
eth0 Speed
eth0 Duplex
eth1 MAC
eth1 Max Speed
eth1 Speed
eth1 Duplex
3.
Create a bond for the 2x 10GB interfaces using the following command:
28
DR4100 Best Practice Guide | April 2014
Example
Example
: bond0
: yes
: yes
: dhcp
: 10.250.242.173
: 255.255.252.0
: 10.250.240.1
: BC:30:5B:F3:22:74
: 9000
: "mode=balance-alb miimon=100 xmit_hash_policy=2"
: eth0,eth1
: BC:30:5B:F3:22:74
:1000baseT/Full
:1000Mb/s
:Full
: BC:30:5B:F3:22:75
:1000baseT/Full
:1000Mb/s
:Full