Dell PowerVault DR4100 모범 사례 매뉴얼 - 페이지 28

{카테고리_이름} Dell PowerVault DR4100에 대한 모범 사례 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DR4100 41 페이지. Backup and recovery appliance
Dell PowerVault DR4100에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (10 페이지), 매뉴얼 (37 페이지), 릴리스 노트 (16 페이지), 매뉴얼 (12 페이지), 매뉴얼 (24 페이지), 매뉴얼 (23 페이지), Qiuck 설정 (1 페이지), 매뉴얼 (27 페이지), 매뉴얼 (25 페이지)

페이지 인쇄

Set bond0 to 1GB using the following command:

network --factory_reset [--auto_bonding_speed <1G|10G>]

administrator@DR1 > network -- factory_reset –auto_bonding_speed 1G

Warning: This will stop all system operation and will reset the network configuration to

factory settings and will require a system robbon. Existing configuration will be lost.

One or more of these interfaces 'eth0,eth1' are in use by an application.

Factory reset cannot be done while interfaces are in use by an application.

Factory reset will remove all application interface settings.

Password required to proceed. Please enter the administrator password :

administrator@DR1 > System --reboot

Use the following command to view the new configuration:

network --show

administrator@DR1 > network -- show

Automatic bonding speed: 1G

Device

Enabled

Link

Boot protocol

IP Addr

Netmask

Gateway

MAC Addr

MTU

Bonding options

Member Interfaces

eth0 MAC

eth0 Max Speed

eth0 Speed

eth0 Duplex

eth1 MAC

eth1 Max Speed

eth1 Speed

eth1 Duplex

Create a bond for the 2x 10GB interfaces using the following command:

DR4100 Best Practice Guide | April 2014

Example

: bond0

: yes

: dhcp

: 10.250.242.173

: 255.255.252.0

: 10.250.240.1

: BC:30:5B:F3:22:74

: 9000

: "mode=balance-alb miimon=100 xmit_hash_policy=2"

: eth0,eth1

: BC:30:5B:F3:22:74

:1000baseT/Full

:1000Mb/s

:Full

: BC:30:5B:F3:22:75

:1000baseT/Full

:1000Mb/s

:Full