Dell PowerVault DR4100 모범 사례 매뉴얼 - 페이지 30

{카테고리_이름} Dell PowerVault DR4100에 대한 모범 사례 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DR4100 41 페이지. Backup and recovery appliance
Dell PowerVault DR4100에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (10 페이지), 매뉴얼 (37 페이지), 릴리스 노트 (16 페이지), 매뉴얼 (12 페이지), 매뉴얼 (24 페이지), 매뉴얼 (23 페이지), Qiuck 설정 (1 페이지), 매뉴얼 (27 페이지), 매뉴얼 (25 페이지)

페이지 인쇄

Scenario 3: Replication between sites with dedicated interfaces

6.3.1.5

Daniel has two sites, each with a DR appliance that he wishes to configure as a replication pair over dedicated links.

Each DR appliance will have the following configuration:

• DR1 has 2x 10GB interfaces in bond0 with 2 x1GB interfaces not bonded dedicated to replication

• DR2 has 2x 10GB interfaces in bond0 with 2 x10GB interfaces not bonded dedicated to replication

Figure 5

In the default configuration of the DR, the default route for the system is always is set on the network which belongs to

bond0. In this example for both the DRs the default route points to the gateway on the 10.250.232.x network. This allows

for administration of the DR from anywhere on the network.

Example route:

[root@DR1 ~]# route

Kernel IP routing table

Destination Gateway

10.250.232.0 *

default

In order for the two DRs to replicate over the dedicated links, static routes should be provisioned in such a way that the

replication flows over those paths. This is done in the steps below.

DR4100 Best Practice Guide | April 2014

Scenario 3 topology

Genmask

255.255.248.0 U

10.250.232.1 0.0.0.0

Flags Metric Ref Use Iface

0 bond0

UG 0

0 bond0