HP ProCurve 1600M Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih HP ProCurve 1600M. HP ProCurve 1600M 28 halaman. Redundant power supply
Juga untuk HP ProCurve 1600M: Lembar Spesifikasi (12 halaman), Baca Saya Terlebih Dahulu (8 halaman), Panduan Peninjau (27 halaman), Panduan Tambahan (2 halaman), Panduan Tambahan (2 halaman), Panduan Instalasi (36 halaman), Panduan Instalasi (28 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (4 halaman), Panduan Pengguna (8 halaman), Suplemen Manual (28 halaman), Baca Saya Terlebih Dahulu (16 halaman), Instalasi dan Penghapusan (2 halaman), Panduan Instalasi (12 halaman), Panduan Perencanaan dan Pelaksanaan (40 halaman), Petunjuk Pembongkaran Akhir Masa Pakai Produk (2 halaman), Panduan Instalasi (46 halaman), Panduan Diagnostik (2 halaman), Petunjuk Pembongkaran (2 halaman)

Halaman Cetak
HP ProCurve 1600M Panduan Instalasi
N o t e

Installing the Module

Overview

You can install any of the modules into any of the HP Procurve switches that
have a compatible module slot. As of this printing, those are the HP Procurve
Switch 4108GL (J4865A) and the HP Procurve Switch 4108GL Bundle
(J4861A).
The installation steps are:
1.
If you are using the Gigabit Transceiver GL Module, install the transceivers
in the module, before installing that module into the switch. Please see
the Installation Guide that came with the transceivers for more informa-
tion on installing the transceivers.
2.
Install the modules in a switch slot (see page 4).
3.
Reset the switch, only if you have installed any modules into slots that
were previously occupied by a different type module (see page 12).
4.
Verify that the modules are installed correctly (see page 6).
5.
Connect the network cabling (see page 7).
6.
Optionally, customize the configuration for the modules' ports (unless the
default port configuration is satisfactory for your network application -
see page 10).
If necessary, you can "hot-swap" one module for another; that is, replace one
module with another while the switch is still powered on, without interrupting
the operation of the rest of the switch ports. For more information, see page 11.
Installing the Module
3