HP ProCurve 1600M Manual de instalación - Página 9

N o t e

Installing the Module

You can install any of the modules into any of the HP Procurve switches that

have a compatible module slot. As of this printing, those are the HP Procurve

Switch 4108GL (J4865A) and the HP Procurve Switch 4108GL Bundle

(J4861A).

The installation steps are:

If you are using the Gigabit Transceiver GL Module, install the transceivers

in the module, before installing that module into the switch. Please see

the Installation Guide that came with the transceivers for more informa-

tion on installing the transceivers.

Install the modules in a switch slot (see page 4).

Reset the switch, only if you have installed any modules into slots that

were previously occupied by a different type module (see page 12).

Verify that the modules are installed correctly (see page 6).

Connect the network cabling (see page 7).

Optionally, customize the configuration for the modules' ports (unless the

default port configuration is satisfactory for your network application -

see page 10).

If necessary, you can "hot-swap" one module for another; that is, replace one

module with another while the switch is still powered on, without interrupting

the operation of the rest of the switch ports. For more information, see page 11.

Installing the Module