HP StorageWorks 2/140 - Director Switch Panduan Petunjuk Instalasi - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Beralih HP StorageWorks 2/140 - Director Switch. HP StorageWorks 2/140 - Director Switch 22 halaman. Director power cord advisory instruction
Juga untuk HP StorageWorks 2/140 - Director Switch: Catatan Rilis (27 halaman), Catatan Rilis (24 halaman), Catatan Rilis (20 halaman), Catatan Rilis (13 halaman), Catatan Rilis (11 halaman), Catatan Rilis (10 halaman), Instruksi (1 halaman)

Halaman Cetak

HP StorageWorks 2/140 - Director Switch Panduan Petunjuk Instalasi

Installation Instructions

Power-On Self Test

Once the Director 2/140 is connected to a power source, a Power-On Self Test (POST)

is initiated. The following sequence of events occur during the POST:

1. Amber LEDs on both CTP cards and all FPM cards illuminate momentarily.

2. The green LED on each CTP card (active and backup) lights as the card is tested

and FPM cards are tested.

3. Green LEDs associated with Fibre Channel ports sequentially illuminate as the

ports are tested.

After successful POST completion, the green power LED on the front bezel, green

LED on the active CTP card, and green PWR OK LEDs on both power supplies

remain illuminated.

If a POST error or other malfunction occurs, refer to the "Maintenance Analysis

Procedures" section in the hp StorageWorks director 2/140 service manual.

Further Setup

For additional information on installing and configuring the Director 2/140, please see

the hp StorageWorks director 2/140 installation guide.

director 2/140 rack mount kit installation instructions