HP StorageWorks 2/140 - Director Switch Kurulum Talimatları Kılavuzu - Sayfa 22

Anahtar HP StorageWorks 2/140 - Director Switch için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. HP StorageWorks 2/140 - Director Switch 22 sayfaları. Director power cord advisory instruction
Ayrıca HP StorageWorks 2/140 - Director Switch için: Yayın Notu (27 sayfalar), Yayın Notu (24 sayfalar), Yayın Notu (20 sayfalar), Yayın Notu (13 sayfalar), Yayın Notu (11 sayfalar), Yayın Notu (10 sayfalar), Talimatlar (1 sayfalar)

Sayfayı Yazdır

HP StorageWorks 2/140 - Director Switch Kurulum Talimatları Kılavuzu

Installation Instructions

Power-On Self Test

Once the Director 2/140 is connected to a power source, a Power-On Self Test (POST)

is initiated. The following sequence of events occur during the POST:

1. Amber LEDs on both CTP cards and all FPM cards illuminate momentarily.

2. The green LED on each CTP card (active and backup) lights as the card is tested

and FPM cards are tested.

3. Green LEDs associated with Fibre Channel ports sequentially illuminate as the

ports are tested.

After successful POST completion, the green power LED on the front bezel, green

LED on the active CTP card, and green PWR OK LEDs on both power supplies

remain illuminated.

If a POST error or other malfunction occurs, refer to the "Maintenance Analysis

Procedures" section in the hp StorageWorks director 2/140 service manual.

Further Setup

For additional information on installing and configuring the Director 2/140, please see

the hp StorageWorks director 2/140 installation guide.

director 2/140 rack mount kit installation instructions