HP Xw460c - ProLiant - Blade Workstation Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Beralih HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 10 halaman. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
Juga untuk HP Xw460c - ProLiant - Blade Workstation: Panduan Pelaksanaan (35 halaman), Panduan Pencegahan Kesalahan (12 halaman), Buku Putih Teknis (12 halaman), Pembaruan Firmware (9 halaman), Panduan Instalasi (2 halaman), Panduan Pertanyaan yang Sering Diajukan (14 halaman), Poster Pengaturan (9 halaman), Panduan Instalasi (33 halaman), Panduan Manajemen (28 halaman), Manual Perangkat Keras (23 halaman), Ikhtisar (35 halaman), Panduan Pengguna (33 halaman), Panduan Pengoptimalan (13 halaman), Garansi Terbatas (10 halaman), Panduan Petunjuk Instalasi (8 halaman), Petunjuk Instalasi (4 halaman), Petunjuk Instalasi (2 halaman)

Halaman Cetak
HP Xw460c - ProLiant - Blade Workstation Panduan Petunjuk Instalasi
If a high-profile Quadro FX 560M is installed, it will appear similar to the following picture—continue with Step 4B
to remove this board.
Steps 4A and 4B—Remove the current graphics board
Steps 4A and 4B both require the removal of the current graphics board in order to access the connector beneath
the board. In Step 4A, the current graphics board (a low-profile Quadro FX 560M) is retained for re-use. In Step
4B, the current graphics board (either a high-profile Quadro FX 560M, a Quadro FX 540M, or a Quadro FX
1600M) is not re-used. Before presenting Steps 4A and 4B, the common board removal tasks are described.
Remove the blade workstation if it is still mounted in the rack. Removal of the blade workstation from the rack and
removal of the blade workstation access panel is described in the document HP ProLiant BL460c Server Blade
Maintenance and Service Guide, available at http://www.hp.com/support/xw460c_manuals. Follow the
instructions in the Maintenance and Service Guide to:
1.
Power down the blade workstation.
2.
Remove the blade workstation from the rack.
3.
Remove the blade workstation access panel.
- 7 -