Olympus MX61L Panduan Perakitan - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Mikroskop Olympus MX61L. Olympus MX61L 49 halaman. 200mm/300mm compatible semiconductor/fpd inspection microscopes

Halaman Cetak

Fig. 10

Fig. 11

Fig. 12

Attaching the Objectives

# Never attempt to rotate the motorized revolving nosepiece by hand.

Rotating by hand may cause malfunction or damage.

Remove the cap from each objective mount hole.

1. Following the order of numbers 1 to 5 or 6 indicated on the objective

mount thread @, screw objectives into the objective mount threads by

starting with the objective with the lowest power.

# The rotation of the revolving nosepiece can be made smooth by

mounting objectives uniformly in all of the nosepiece positions.

Therefore, the objectives that are not used frequently should also

be mounted.

Be sure to attach the caps to the unused objective mount hole.

Using the Brightfield Objective Adapter

When mounting a brightfield objective on a revolving nosepiece designed

for brightfield/darkfield objectives, mount each objective by means of the

BD-M-AD objective adapter.

Attaching the Motorized Revolving Nosepiece

# It is only the U-D5BDREMC, U-D6REMC or U-P5REMC revolving nose-

piece that can be used.

# Lower the stage far enough to ensure that the objectives do not

touch the stage when mounting the revolving nosepiece.

# Slide the revolving nosepiece all the way into the dovetail mount

until it stops.

# The revolving nosepiece is a heavy module. Take care not to drop it

during mounting.

1. Loosen the revolving nosepiece clamping screw @ using the provided

Allen screwdriver, slide the revolving nosepiece all the way into the

dovetail mount until it stops, and tighten the clamping screw @.

# If the clamping screw is tightened without sliding the revolving

nosepiece all the way, the clamping section may be deformed,

the revolving nosepiece may become irremovable, and the connector

contact failure may occur also.

2. Set the DIP switches for the mounted revolving nosepiece (see page 20

for the setup method).

Attaching the Observation Tube

1. Using the provided Allen screwdriver, fully loosen the observation tube

clamping screw @.

2. Insert the circular dovetail mount at the bottom of the observation tube

into the observation tune mount on the top surface of the arm.

3. Clamp the observation tube by tightening the clamping screw @.

MX61/MX61L

(Fig. 10)

(Fig. 11)

(Fig. 12)