FIAMA F7- Panduan Pengguna dan Pemeliharaan - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna dan Pemeliharaan untuk Monitor FIAMA F7-. FIAMA F7- 12 halaman. Display for magnetic band with battery power supply
Halaman Cetak
Display for magnetic band
• The configurations provided in the manual are the only ones permitted.
• Do not try to use it anyway contrary to the indications provided.
• The instructions in this manual do not substitute but accomplish the obligations of the current
legislation regarding the safety laws.
Installation
Before installing the instrument, read the following warnings:
a) Connect the instrument strictly following the instructions of the manual.
b) It is the responsibility of the user to check, before using, the correct settings of the parameters of
the instrument to avoid damage to persons or things.
c) The instrument CANNOT function in a dangerous environment (inflammable or explosive).
d) The unit has sensible parts to electrostatic charge, therefore the handling of the inner electronic
cards has to be carried out with appropriate care to avoid permanent damages.
Description
The F7 is a display unit with integrated position sensor, in combination with the P50 magnetic
band, is a complete system to measure linear movements.
The display has five digits plus sign (range from -99999 up to +99999). The digits are 7.5mm high
to allow excellent readability also at a distance.
It is possible to select the counting direction, the number of decimal places, and the units (mm or
inches). The displayed value can be corrected with a multiplication factor, with values between
0.001 and 99999.
The instrument can count in absolute mode or relative mode by pressing the corresponding
button. Also, it is possible to set a preset value which can be activated by pressing the
corresponding button.
The electronics are protected by a plastic housing which is robust, shock-resistant, and self-
extinguishing.
Two versions of the F7 are available:
•
F7-E with external sensor
•
F7-I with integrated sensor
The display can be fixed quickly and easily using the two threaded holes on the back of the
housing or alternatively with the SM bracket support or the SF flanged support which can be
supplied optionally.
The unit is powered by a ½AA 3.6V battery which lasts approximately 4 years and when the
battery is almost exhausted, an icon will appear to advise the operator to substitute it. This does
not effect the configuration parameters and also the correct measurement is maintained if the
magnetic band is not moved during this operation.
Programming
To step into the parameter programming press key
press 2 times key
RESET
increase) and
(digit selection), set out password 0273 and confirm with
wrong set-out of password it goes out of the programming. The parameters that have to be set
can be run with key
value to be displayed for 10mm of sensor displacement,
number of decimal digits,
keys opening mode
count direction,
To enter into the modification of the selected parameter press two times
only the value) and with keys
To go out of the programming press
Value to be displayed for 10 mm of sensor displacement
Data: 13/01/16
and appear 4 zeroes, the first on the right is blinking, with keys
and in order of appearance they are:
and
set the wanted value to be confirmed with
.
and on the display appears
F7_ing.doc
F7
, now
(digit
. In case of
RESET
(one time displays
RESET
.
RESET
pag 3/12