Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 20

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Beralih Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Catatan Instalasi (14 halaman), Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Catatan Instalasi (24 halaman), Manual (19 halaman)

Removing a DFC4 Daughter Card

Partially reinstall a cap nut, rotating it about 3 turns so that there is a space of about 1/8 inch (3 mm)

Step 5

between the bottom of the cap nut and the top of the DFC4 daughter card, as shown in

cap nut acts as a stop when you unseat the daughter card connector so that the DFC4 daughter card does

not move horizontally and cause damage to the Ethernet module.

Figure 10

Appx 1/8 inch

With your left hand, lift slightly at the location shown in

Step 6

rock the DFC4 daughter card up and down with your right hand, no more than half an inch in either

direction, to unseat the DFC4 daughter card from the module.

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

Partially Installing the Cap Nut

Cap nut

Figure

11. While lifting with your left hand,

Figure

10. The

OL-24918-02