Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 20

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Kurulum Notu (46 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar)

Removing a DFC4 Daughter Card

Partially reinstall a cap nut, rotating it about 3 turns so that there is a space of about 1/8 inch (3 mm)

Step 5

between the bottom of the cap nut and the top of the DFC4 daughter card, as shown in

cap nut acts as a stop when you unseat the daughter card connector so that the DFC4 daughter card does

not move horizontally and cause damage to the Ethernet module.

Figure 10

Appx 1/8 inch

With your left hand, lift slightly at the location shown in

Step 6

rock the DFC4 daughter card up and down with your right hand, no more than half an inch in either

direction, to unseat the DFC4 daughter card from the module.

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

Partially Installing the Cap Nut

Cap nut

Figure

11. While lifting with your left hand,

Figure

10. The

OL-24918-02