Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 18

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Kurulum Notu (46 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar)

Removing a DFC4 Daughter Card

Figure 7

Unseat the

DFC power

connector

Removing a DFC4 Daughter Card

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

Warning

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To remove the DFC4 daughter card from an Ethernet module, follow these steps:

Attach an ESD grounding strap to your wrist and to ground.

Step 1

Remove the Ethernet module from the chassis.

Step 2

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

Place the Ethernet module on an antistatic mat with the front of the module facing toward you.

Step 3

Remove the DFC4 daughter card mounting hardware. See

Step 4

or WS-F6K-EXL daughter card mounting hardware. See

or WS-F6K-DFC4-AXL daughter card mounting hardware.

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

Removing the DFC3 Daughter Card from the Module

Lift here

WS-X5530

"Removing an Ethernet Module from the Chassis" section on page 28

Lift here

for removal instructions.

Figure 8

for removing the WS-F6K-DFC4-E

Figure 9

for removing the WS-F6K-DFC4-A

OL-24918-02