Cisco 9134 - MDS Multilayer Fabric Switch Panduan Konfigurasi - Halaman 42

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 49 halaman. Mds 9000 series
Juga untuk Cisco 9134 - MDS Multilayer Fabric Switch: Spesifikasi (3 halaman), Catatan Rilis (48 halaman), Catatan Rilis (44 halaman), Catatan Rilis (22 halaman), Catatan Rilis (3 halaman), Catatan Rilis (40 halaman), Catatan Rilis (10 halaman), Manual (16 halaman), Panduan Pemasangan Perangkat Keras (36 halaman)

Figure 38 Selecting Load Balance Policy

Repeat steps 3 through 6 for the other target.

On the iSCSI-enabled C-Series Fibre Channel switch in the IP > iSCSI window, click the Session

Initiators tab to verify C-Series iSCSI sessions

Figure 39 Verifying C-Series iSCSI sessions

Conﬁguring p-Class Blade servers in an iSCSI environment

This section describes the procedures to prepare a p-Class Blade server for inclusion in an iSCSI

environment. Each Blade server enclosure has a pair of network interconnects located at the left most and

right most positions in the enclosure. They transmit and receive all Ethernet and Fibre Channel signals

between installed Blade servers. The interconnect modules are based on either the Cisco Gigabit Ethernet

Switch Module (CGESM) or the Gibabit Ethernet 2 (GbE2) standards.

Conﬁguring p-Class Blade CGESM server enclosure interconnects

This section describes a conﬁguration example using CGESM interconnects. For details on the

conﬁguration or installation of the interconnects, see the speciﬁc Blade server documentation.

(Figure

39).