Siemens SINAMICS G120 Panduan Petunjuk Pengoperasian - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 32 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pengoperasian yang Ringkas (32 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

Commissioning

4.1 Commissioning with STARTER or Startdrive

Loading the configured data into the drive

Procedure with STARTER

Proceed as follows to load the configured data into the drive:

1. Select your drive.

2. Go online:

STARTER compares your configuration with the real inverter. STARTER signals any

differences in the "Online/offline comparison".

Acknowledge the message by pressing the "Load HW configuration to PG" button.

3. Open "Drive Navigator".

4. Select the "Commissioning" button.

5. Click on "Load data to the drive".

6. ☑ In the following screen form, select "After loading copy RAM to ROM".

7. Load your configuration into the inverter.

8. Wait until loading has been completed.

9. Close the "Commissioning" screen form.

You have loaded your configuration into the drive and therefore commissioned the system.

Procedure with Startdrive

Proceed as follows to load the configured data into the drive:

1. Select your drive.

2. Press the "Load to device" button.

3. ☑ In the following screen form, select "Back up parameter assignment in the EEPROM".

4. Load your configuration into the inverter.

5. Wait until loading has been completed.

You have loaded your configuration into the drive and therefore commissioned the system.

Compact Operating Instructions, 01/2016, A5E37058195B AA

CU250S-2 Control Units