Siemens SINAMICS G120 Petunjuk Pengoperasian yang Ringkas - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian yang Ringkas untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 32 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Panduan Petunjuk Pengoperasian (32 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

3.4

Terminal strips on CU240E-2 Control Units

Terminal strips with wiring example

All terminals labelled with reference potential "GND" are connected internally in the inverter.

Reference potentials "DI COM1" and "DI COM2" are electrically isolated from "GND".

→ If, as shown above, the 24 V supply from terminal 9 is used to supply the digital inputs, then you

must connect "GND", "DI COM1" and "DI COM2" with one another.

Terminals 31, 32

Reference potential "GND IN" is electrically isolated from "GND". When an optional 24 V power supply

is connected at terminals 31, 32, even when the Power Module is disconnected from the line supply,

the Control Unit remains in operation. The Control Unit thus maintains the fieldbus communication, for

example.

→ at terminals 31, 32, only connect a power supply that is in accordance with SELV (Safety Extra Low

Voltage) or PELV (Protective Extra Low Voltage).

→ if you use a common external power supply for terminals 31, 32 and the digital inputs, you must

connect "GND" to "GND IN".

Terminals 3, 4

You may use the internal 10V power supply or an external power supply for the analog inputs.

and 10, 11:

→ If you use the internal 10 V power supply, you must connect AI 0- or AI 1- to GND.

Figure 3-4

Wiring example of the digital inputs with the internal inverter 24 V power supply

CU240B-2 and CU240E-2 Control Units

Compact Operating Instructions, 04/2015, A5E35792002B AA

3.4 Terminal strips on CU240E-2 Control Units

Installing