Siemens SINAMICS G120 Petunjuk Pengoperasian yang Ringkas - Halaman 19

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian yang Ringkas untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 32 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Panduan Petunjuk Pengoperasian (32 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

4.2

Commissioning with BOP-2 operator panel

Plugging on an operator panel

Procedure

To plug an Operator Panel on the Control Unit, proceed as follows:

1. Locate the lower edge of the Operator Panel into the matching recess

of the Control Unit.

2. Press the Operator Panel onto the inverter until you hear the latching

mechanism engage.

You have plugged an operator panel onto the Control Unit.

The operator panel is ready for operation when you connect the inverter

to the power supply.

4.2.1

Carry out basic commissioning

Preconditions

Procedure

Proceed as follows to carry out basic commissioning:

CU240B-2 and CU240E-2 Control Units

Compact Operating Instructions, 04/2015, A5E35792002B AA

• The power supply is switched on.

• The operator panel displays setpoints and actual values.

Press the ESC key.

Press one of the arrow keys until the BOP-2 displays the "SETUP" menu.

In the "SETUP" menu, press the OK key to start basic commissioning.

If you wish to restore all of the parameters to the factory setting before

the basic commissioning:

4.1.

Switch over the display using an arrow key: nO → YES

4.2.

Press the OK key.

When selecting an application class, the inverter assigns the appropri-

ate default settings to the motor control:

STANDARD

DYNAMIC

EXPERT

4.2 Commissioning with BOP-2 operator panel

→ Standard Drive Control (Page 21)

→ Dynamic Drive Control (Page 23)

The approach is described in the operating instructions

→ Manuals for your inverter (Page 31)

Commissioning