Siemens SINAMICS G120 Petunjuk Pengoperasian yang Ringkas - Halaman 24

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian yang Ringkas untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 32 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Panduan Petunjuk Pengoperasian (32 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

Commissioning

4.2 Commissioning with BOP-2 operator panel

10.

11.

12.

13.

14.

15.

16.

17.

You have entered all of the data that is necessary for the basic commissioning of your

inverter.

Select the application:

OP LOOP Recommended setting for standard applications.

CL LOOP

HVY LOAD Recommended setting for applications with a high break

Select the default setting for the interfaces of the inverter that is suita-

ble for your application. The available default settings can be found in

the operating instructions, see: Manuals for your inverter (Page 31).

Minimum and maximum motor speed

Motor ramp-up time

Motor ramp-down time

Ramp-down time for the OFF3 command

Motor data identification

Select the method which the inverter uses to measure the data of the

connected motor:

OFF

ST RT OP Recommended setting: Measure the motor data at stand-

STILL OP

Complete the basic commissioning:

17.1. Switch over the display using an arrow key: nO → YES

17.2. Press the OK key.

Recommended setting for applications with short ramp-

up and ramp-down times. This setting is not suitable for

hoisting gear and cranes/lifting gear.

loose torque.

Motor data is not measured.

still and with the motor rotating.

Measure the motor data at standstill.

Select this setting if the motor cannot rotate freely – for

example, if the traversing range is mechanically limited.

Compact Operating Instructions, 04/2015, A5E35792002B AA

CU240B-2 and CU240E-2 Control Units