Siemens SIREMOBIL Iso-C Manual Petunjuk Instalasi dan Pengaturan - Halaman 3
Jelajahi secara online atau unduh pdf Manual Petunjuk Instalasi dan Pengaturan untuk Peralatan Industri Siemens SIREMOBIL Iso-C. Siemens SIREMOBIL Iso-C 6 halaman.
Juga untuk Siemens SIREMOBIL Iso-C: Petunjuk Instalasi dan Pengaturan (4 halaman), Manual Petunjuk Servis (16 halaman), Instruksi Pemeliharaan (46 halaman), Panduan Petunjuk Instalasi (6 halaman)
Halaman Cetak
Installing a Video Printer
CAUTION
If the MS2000 multiformat camera is connected
Power cable
Videoprinter with 100VAC line voltage:
Connect the line wires to transformer T1, connector TI - 34 and TI - 36.
Connect the protective conductor to the protective conductor terminal stripe (ye/gn).
Videoprinter with 120VAC line voltage:
Connect the line wires to transformer T1, connector TI - 35 and TI - 36.
Connect the protective conductor to the protective conductor terminal stripe (ye/gn).
Videoprinter with 230VAC line voltage:
•
Connect the line wires of the video printer at terminals X2.1 and X2.2.
•
Connect the protective conductor at the corresponding location (yellow/green).
•
Route the line wires to the video printer compartment.
Hardcopy exposure control cable
•
Route the end of the cable with the 3.5 mm jack plug to the video printer compartment.
Video cable
•
Disconnect the 75 ohm termination from the video output of the multiformat camera.
•
Connect the video cable to the multiformat camera and route it to the video printer
compartment.
•
Connect the video printer. Ensure the proper termination of the video cable
(75 ohm).
Function test
•
Call up a fluoroscopic image on monitor A or monitor B.
•
Release an exposure at the operating panel of the basic system and at the monitor
trolley keyboard.
Siemens AG
Medical Engineering
Disconnect the SIREMOBIL Iso-C from the main power supply
prior to beginning this procedure.
The video printer should print an image in both cases.
Register 3
SPR2-230.033.02
Rev. 02
10.99
Page 3 of 6
SIREMOBIL Iso-C
TD SD 24
3
1
1
1
1
1