Siemens SIREMOBIL Iso-C 설치 및 설정 지침 매뉴얼 - 페이지 3
{카테고리_이름} Siemens SIREMOBIL Iso-C에 대한 설치 및 설정 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIREMOBIL Iso-C 6 페이지.
Siemens SIREMOBIL Iso-C에 대해서도 마찬가지입니다: 설치 및 설정 지침 (4 페이지), 서비스 지침 매뉴얼 (16 페이지), 유지 관리 지침 (46 페이지), 설치 지침 매뉴얼 (6 페이지)
페이지 인쇄
Installing a Video Printer
CAUTION
If the MS2000 multiformat camera is connected
Power cable
Videoprinter with 100VAC line voltage:
Connect the line wires to transformer T1, connector TI - 34 and TI - 36.
Connect the protective conductor to the protective conductor terminal stripe (ye/gn).
Videoprinter with 120VAC line voltage:
Connect the line wires to transformer T1, connector TI - 35 and TI - 36.
Connect the protective conductor to the protective conductor terminal stripe (ye/gn).
Videoprinter with 230VAC line voltage:
•
Connect the line wires of the video printer at terminals X2.1 and X2.2.
•
Connect the protective conductor at the corresponding location (yellow/green).
•
Route the line wires to the video printer compartment.
Hardcopy exposure control cable
•
Route the end of the cable with the 3.5 mm jack plug to the video printer compartment.
Video cable
•
Disconnect the 75 ohm termination from the video output of the multiformat camera.
•
Connect the video cable to the multiformat camera and route it to the video printer
compartment.
•
Connect the video printer. Ensure the proper termination of the video cable
(75 ohm).
Function test
•
Call up a fluoroscopic image on monitor A or monitor B.
•
Release an exposure at the operating panel of the basic system and at the monitor
trolley keyboard.
Siemens AG
Medical Engineering
Disconnect the SIREMOBIL Iso-C from the main power supply
prior to beginning this procedure.
The video printer should print an image in both cases.
Register 3
SPR2-230.033.02
Rev. 02
10.99
Page 3 of 6
SIREMOBIL Iso-C
TD SD 24
3
1
1
1
1
1