Siemens SIREMOBIL Iso-C Kurulum ve Ayar Talimatları Kılavuzu - Sayfa 3

Endüstriyel Ekipmanlar Siemens SIREMOBIL Iso-C için çevrimiçi göz atın veya pdf Kurulum ve Ayar Talimatları Kılavuzu indirin. Siemens SIREMOBIL Iso-C 6 sayfaları.
Ayrıca Siemens SIREMOBIL Iso-C için: Kurulum ve Ayar Talimatları (4 sayfalar), Servis Talimatları Kılavuzu (16 sayfalar), Bakım Talimatı (46 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar)

Installing a Video Printer

CAUTION

If the MS2000 multiformat camera is connected

Power cable

Videoprinter with 100VAC line voltage:

Connect the line wires to transformer T1, connector TI - 34 and TI - 36.

Connect the protective conductor to the protective conductor terminal stripe (ye/gn).

Videoprinter with 120VAC line voltage:

Connect the line wires to transformer T1, connector TI - 35 and TI - 36.

Connect the protective conductor to the protective conductor terminal stripe (ye/gn).

Videoprinter with 230VAC line voltage:

•

Connect the line wires of the video printer at terminals X2.1 and X2.2.

•

Connect the protective conductor at the corresponding location (yellow/green).

•

Route the line wires to the video printer compartment.

Hardcopy exposure control cable

•

Route the end of the cable with the 3.5 mm jack plug to the video printer compartment.

Video cable

•

Disconnect the 75 ohm termination from the video output of the multiformat camera.

•

Connect the video cable to the multiformat camera and route it to the video printer

compartment.

•

Connect the video printer. Ensure the proper termination of the video cable

(75 ohm).

Function test

•

Call up a fluoroscopic image on monitor A or monitor B.

•

Release an exposure at the operating panel of the basic system and at the monitor

trolley keyboard.

Siemens AG

Medical Engineering

Disconnect the SIREMOBIL Iso-C from the main power supply

prior to beginning this procedure.

The video printer should print an image in both cases.

SPR2-230.033.02

Rev. 02

10.99

Page 3 of 6

SIREMOBIL Iso-C

TD SD 24