Cisco NCS 5500 Series Manual Koneksi - Halaman 21

Jelajahi secara online atau unduh pdf Manual Koneksi untuk Router Jaringan Cisco NCS 5500 Series. Cisco NCS 5500 Series 24 halaman. Connect router to the network
Juga untuk Cisco NCS 5500 Series: Panduan Konfigurasi (19 halaman), Manual (25 halaman)

Halaman Cetak
Cisco NCS 5500 Series Manual Koneksi
Connect Router to the Network
Figure 19: Installing a CFP2 Module into a Port Socket
Step 5
When you are ready to attach the network cable interface, remove the dust plugs and inspect and clean fiber connector
end faces, and then immediately attach the network interface cable connectors into the CFP2 module optical bores.
Removing a CFP2 Module
To remove a CFP2 module, follow these steps:
Step 1
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2
Disconnect and remove all interface cables from the ports; note the current connections of the cables to the ports on the
line card.
Step 3
Open the bail latch on the CFP2 module with your index finger. If the bail latch is obstructed and you cannot use your
index finger to open it, use a small flat-blade screwdriver or other long, narrow instrument to open the bail latch.
Step 4
Grasp the CFP2 module between your thumb and index finger and carefully remove it from the port.
Step 5
Place the removed CFP2 module on an antistatic mat, or immediately place it in a static shielding bag if you plan to return
it to the factory.

Connect Interface Ports

You can connect optical interface ports on line cards with other devices for network connectivity.
Connect a Fiber-Optic Port to the Network
Depending on the line card model that you are using, you can use either QSFP+ or QSFP28 transceivers.
Some transceivers work with fiber-optic cables that you attach to the transceivers and other transceivers work
with pre-attached copper cables. When installing fiber-optic cables for a port, you must install SFP transceivers
for 1-Gigabit optical ports or install SFP+ transceivers for 10-Gigabit optical ports or QSFP+ transceivers for
100-Gigabit ports before installing the fiber-optic cable in the transceivers.
Removing a CFP2 Module
Connect Router to the Network
21