Cisco NCS 5500 Series 연결 매뉴얼 - 페이지 21

{카테고리_이름} Cisco NCS 5500 Series에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco NCS 5500 Series 24 페이지. Connect router to the network
Cisco NCS 5500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 매뉴얼 (25 페이지)

페이지 인쇄

Connect Router to the Network

Figure 19: Installing a CFP2 Module into a Port Socket

Step 5

When you are ready to attach the network cable interface, remove the dust plugs and inspect and clean fiber connector

end faces, and then immediately attach the network interface cable connectors into the CFP2 module optical bores.

Removing a CFP2 Module

To remove a CFP2 module, follow these steps:

Step 1

Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Step 2

Disconnect and remove all interface cables from the ports; note the current connections of the cables to the ports on the

line card.

Step 3

Open the bail latch on the CFP2 module with your index finger. If the bail latch is obstructed and you cannot use your

index finger to open it, use a small flat-blade screwdriver or other long, narrow instrument to open the bail latch.

Step 4

Grasp the CFP2 module between your thumb and index finger and carefully remove it from the port.

Step 5

Place the removed CFP2 module on an antistatic mat, or immediately place it in a static shielding bag if you plan to return

it to the factory.

Connect Interface Ports

You can connect optical interface ports on line cards with other devices for network connectivity.

Connect a Fiber-Optic Port to the Network

Depending on the line card model that you are using, you can use either QSFP+ or QSFP28 transceivers.

Some transceivers work with fiber-optic cables that you attach to the transceivers and other transceivers work

with pre-attached copper cables. When installing fiber-optic cables for a port, you must install SFP transceivers

for 1-Gigabit optical ports or install SFP+ transceivers for 10-Gigabit optical ports or QSFP+ transceivers for

100-Gigabit ports before installing the fiber-optic cable in the transceivers.

Removing a CFP2 Module

Connect Router to the Network