Cisco 800 Series Panduan Desain - Halaman 38

Jelajahi secara online atau unduh pdf Panduan Desain untuk Titik Akses Nirkabel Cisco 800 Series. Cisco 800 Series 50 halaman. Fast step software design guide
Juga untuk Cisco 800 Series: Catatan Rilis (36 halaman), Panduan Memulai Cepat (13 halaman), Panduan Memulai Cepat (17 halaman), Mengkonfigurasi (32 halaman)

Halaman Cetak

Web Site Support

The Cisco Fast Step_Reset.exe program launches a Web browser and points to the Registration and

Welcome Web sites of the service provider.

Registration Web Site

The registration Web site launches a local Web page. The path is relative to the Cisco 800 Fast Step

installation directory. A Web browser must be installed, and it is automatically launched as a separate

program. The following is an example of the flag in the CFG file:

[Belle Systems]

ISPSetupURL=http://test.cisco.com

Welcome Web Site

The Welcome Web site displays after the router has been registered and configured through Belle

Systems IMS+. The path is relative to the Cisco 800 Fast Step installation directory. A Web browser

must be installed, and it is automatically launched as a separate program. The following is an example

of the flag in the CFG file:

[Belle Systems]

ISPLocalURL=http://www.cisco.com

Service Provider Instructions to End Users

The procedures in this section describe loading a CFG file and a TPL file for the end user. Although it

is likely that you will modify these instructions for individual use, they provide a starting point.

End-User Instructions for CFG Files

Complete the following procedure to load a router configuration by using a Cisco 800 Fast Step CFG

file:

Cable the router as described in the Cisco 800 Fast Step Quick Reference Guide.

Step 1

Locate the instruction sheet that lists the parameters you will need to configure the router.

Step 2

Install Cisco 800 Fast Step software on a PC attached to the router by a configuration cable or connected

Step 3

to the same Ethernet LAN.

Launch Cisco 800 Fast Step Setup. The Welcome window displays.

Step 4

Click Next. The Service Selection window displays.

Step 5

Cisco 800 Fast Step Software Design Guide

4-6

Chapter 4

Custom Software Installation

OL-10373-02