- ページ 38

無線アクセスポイント Cisco 800 SeriesのPDF 設計マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 800 Series 50 ページ。 Fast step software design guide
Cisco 800 Series にも：リリースノート (36 ページ), クイック・スタート・マニュアル (13 ページ), クイック・スタート・マニュアル (17 ページ), 設定 (32 ページ)

Web Site Support

The Cisco Fast Step_Reset.exe program launches a Web browser and points to the Registration and

Welcome Web sites of the service provider.

The registration Web site launches a local Web page. The path is relative to the Cisco 800 Fast Step

installation directory. A Web browser must be installed, and it is automatically launched as a separate

program. The following is an example of the flag in the CFG file:

[Belle Systems]

ISPSetupURL=http://test.cisco.com

The Welcome Web site displays after the router has been registered and configured through Belle

Systems IMS+. The path is relative to the Cisco 800 Fast Step installation directory. A Web browser

must be installed, and it is automatically launched as a separate program. The following is an example

of the flag in the CFG file:

[Belle Systems]

ISPLocalURL=http://www.cisco.com

The procedures in this section describe loading a CFG file and a TPL file for the end user. Although it

is likely that you will modify these instructions for individual use, they provide a starting point.

Complete the following procedure to load a router configuration by using a Cisco 800 Fast Step CFG

file:

Cable the router as described in the Cisco 800 Fast Step Quick Reference Guide.

Step 1

Locate the instruction sheet that lists the parameters you will need to configure the router.

Step 2

Install Cisco 800 Fast Step software on a PC attached to the router by a configuration cable or connected

Step 3

to the same Ethernet LAN.

Launch Cisco 800 Fast Step Setup. The Welcome window displays.

Step 4

Click Next. The Service Selection window displays.

Step 5

Cisco 800 Fast Step Software Design Guide

4-6

Chapter 4

Custom Software Installation

OL-10373-02