Cisco Meraki MR20-HW Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Titik Akses Nirkabel Cisco Meraki MR20-HW. Cisco Meraki MR20-HW 15 halaman. Cloud-managed access point

Halaman Cetak

Check and Upgrade Firmware

To ensure your MR20-HW performs optimally immediately following installation, it is

recommended that you facilitate a ﬁrmware upgrade prior to mounting your MR20-HW.

1. Attach your MR20-HW to power and a wired Internet connection. See the "Power

the MR20-HW" section for details.

2. The MR20-HW will turn on and the LED will glow solid orange. If the unit does not

require a ﬁrmware upgrade, the LED will turn either green (no clients associated)

or blue (clients associated) within thirty seconds.

* If the unit requires an upgrade, the LED will begin blinking orange until the upgrade is

complete, at which point the LED will turn solid green or blue. You should allow at least a

few minutes for the ﬁrmware upgrade to complete, depending on the speed of your

internet connection.

Check and Conﬁgure Firewall Settings

If a ﬁrewall is in place, it must allow outgoing connections on particular ports to particular

IP addresses. The most current list of outbound ports and IP addresses for your particular

organization can be found here.

Assigning IP Addresses to MR20-HWs

All gateway MR20-HWs (MR20-HWs with Ethernet connections to the LAN) must be

assigned routable IP addresses. These IP addresses can be dynamically assigned via

DHCP or statically assigned.

Dynamic Assignment

When using DHCP, the DHCP server should be conﬁgured to assign a static IP address

for each MAC address belonging to a Meraki AP. Other features of the wireless network,

such as 802.1X authentication, may rely on the property that the APs have static IP

addresses.

Static Assignment

Static IPs are assigned using the local web server on each AP. The following procedure

describes how to set the static IP:

1. Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating

to any SSID broadcast by the AP) or over a wired connection.

2. If using a wired connection, connect the client machine to the MR20-HW either

through a PoE switch or a PoE Injector. If using a PoE switch, plug an Ethernet

cable into the MR20-HW's Ethernet jack, and the other end into a PoE switch.

Then connect the client machine over Ethernet cable to the PoE switch. If using a

PoE Injector, connect the MR20-HW to the "PoE" port of the Injector, and the

client machine to the "LAN" port.

3. Using a web browser on the client machine, access the AP's built-in web server by

browsing to http://my.meraki.com. Alternatively, browse to http://10.128.128.128.