Cisco TelePresence IX5200 Pengaturan Pertama Kali - Halaman 12
Jelajahi secara online atau unduh pdf Pengaturan Pertama Kali untuk Sistem Konferensi Cisco TelePresence IX5200. Cisco TelePresence IX5200 40 halaman.
Juga untuk Cisco TelePresence IX5200: Panduan Pengguna Mulai Cepat (15 halaman), Panduan Pengguna (26 halaman), Panduan Instalasi (36 halaman)
Halaman Cetak
Requirements for Whiteboards and Whiteboard Microphones
Press MENU on the remote, or press the center of the joystick and move the joystick to select the menu
Step 2
option (the choice on the left), to bring up the menu for the display.
Step 3
Using the up and down arrows, navigate to System in the menu panel.
Press Enter if using a remote, or press the center of the joystick if using the joystick on the display, to
Step 4
select the System choice.
Step 5
Using the up and down arrows, navigate to General and press either Enter on the remote, or the center
of the joystick on the display.
This choice does not appear initially. Scroll down to see it.
Step 6
Step 7
Navigate to OSD Display and press Enter or the center of the joystick.
Step 8
Set all three OSD choices (Source OSD, No Signal OSD, and MDC OSD) to Off (the default is On) to
disable OSD messages.
Step 9
Press EXIT on the remote, or move the joystick to the previous menu choices, until the menu no longer
displays.
Reboot Required After First-Time Setup For Systems with Auxiliary Displays
If your IX system uses auxiliary displays, you must reboot the system after you complete first-time setup
for the displays to be detected. After reboot, you can rerun First-Time Setup just to verify the auxiliary
display configuration. After the display setup, you can exit First-Time Setup without going through the
entire process again.
If you add an extra auxiliary display, you must run First-Time Setup again. If you unplug or plug a
display cable, or power cycle any auxiliary display, you must reboot the system for the display to be
detected.
Requirements for Whiteboards and Whiteboard Microphones
The IX system supports whiteboard projection. In addition, it supports a microphone to be placed in front
of the whiteboard, so that your voice can be heard by conference participants while you use the
whiteboard.
The following sections provide you with the requirements for whiteboard and whiteboard microphone
placement.
Rules for Whiteboards
The whiteboard must have an aspect ratio of 16:9.
A 3x5-foot whiteboard has a ratio of 15:9, which closely approximates the correct ratio.
Tip
If your whiteboard is not at this ratio, you can adjust the red targets inside the perimeter of the
whiteboard until the ratio is correct.
Cisco TelePresence IX5000 and IX5200 First-Time Setup
12
OL-27038-01