Cisco TelePresence IX5200 최초 설정 - 페이지 12

{카테고리_이름} Cisco TelePresence IX5200에 대한 최초 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence IX5200 40 페이지.
Cisco TelePresence IX5200에 대해서도 마찬가지입니다: 빠른 시작 사용 설명서 (15 페이지), 사용자 설명서 (26 페이지), 설치 매뉴얼 (36 페이지)

페이지 인쇄

Requirements for Whiteboards and Whiteboard Microphones

Press MENU on the remote, or press the center of the joystick and move the joystick to select the menu

Step 2

option (the choice on the left), to bring up the menu for the display.

Step 3

Using the up and down arrows, navigate to System in the menu panel.

Press Enter if using a remote, or press the center of the joystick if using the joystick on the display, to

Step 4

select the System choice.

Step 5

Using the up and down arrows, navigate to General and press either Enter on the remote, or the center

of the joystick on the display.

This choice does not appear initially. Scroll down to see it.

Step 6

Step 7

Navigate to OSD Display and press Enter or the center of the joystick.

Step 8

Set all three OSD choices (Source OSD, No Signal OSD, and MDC OSD) to Off (the default is On) to

disable OSD messages.

Step 9

Press EXIT on the remote, or move the joystick to the previous menu choices, until the menu no longer

displays.

Reboot Required After First-Time Setup For Systems with Auxiliary Displays

If your IX system uses auxiliary displays, you must reboot the system after you complete first-time setup

for the displays to be detected. After reboot, you can rerun First-Time Setup just to verify the auxiliary

display configuration. After the display setup, you can exit First-Time Setup without going through the

entire process again.

If you add an extra auxiliary display, you must run First-Time Setup again. If you unplug or plug a

display cable, or power cycle any auxiliary display, you must reboot the system for the display to be

detected.

Requirements for Whiteboards and Whiteboard Microphones

The IX system supports whiteboard projection. In addition, it supports a microphone to be placed in front

of the whiteboard, so that your voice can be heard by conference participants while you use the

whiteboard.

The following sections provide you with the requirements for whiteboard and whiteboard microphone

placement.

Rules for Whiteboards

The whiteboard must have an aspect ratio of 16:9.

A 3x5-foot whiteboard has a ratio of 15:9, which closely approximates the correct ratio.

Tip

If your whiteboard is not at this ratio, you can adjust the red targets inside the perimeter of the

whiteboard until the ratio is correct.

Cisco TelePresence IX5000 and IX5200 First-Time Setup

OL-27038-01