Cisco TelePresence IX5200 최초 설정 - 페이지 13

{카테고리_이름} Cisco TelePresence IX5200에 대한 최초 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence IX5200 40 페이지.
Cisco TelePresence IX5200에 대해서도 마찬가지입니다: 빠른 시작 사용 설명서 (15 페이지), 사용자 설명서 (26 페이지), 설치 매뉴얼 (36 페이지)

페이지 인쇄

Figure 3

Framing the Whiteboard for Correct Ratio

•

Figure 4

Note

whiteboard camera.

OL-27038-01

There are no minimum or maximum dimensions, but the whiteboard must fit entirely into the field

of view of one of the three cameras. The projected area can overlap between two cameras, but it must

fit entirely into one camera's view.

If you want to place the whiteboard on the wall prior to the system being installed, you can

–

calculate the angle of view for each camera and place the whiteboard accordingly. Each camera

has a 44-degree angle of view (plus or minus 2 degrees). The cameras overlap 11 degrees (plus

or minus 2 degrees). These angles are shown in

It is more difficult to plan for the height of a whiteboard, because of meeting participants or

–

physical obstructions blocking the view. A whiteboard can be placed below the height of the

table, as long as it is within the field of view of the camera.

The whiteboard can be placed on the back wall, or the side wall. The software de-warps the

whiteboard and displays it correctly, regardless of placement.

Figure 4

illustrates correct and incorrect whiteboard placement. The first two whiteboards fit into

the viewing area of the right camera. One is placed on the side wall, and one is placed on the rear

wall. Either placement is acceptable.

The third whiteboard overlaps the area of view for the center and left camera, which is acceptable,

but does not fit into either camera's full area of view, which is unacceptable.

shows two whiteboards, but only one whiteboard per system can be set up and used with the

Requirements for Whiteboards and Whiteboard Microphones

Figure

Cisco TelePresence IX5000 and IX5200 First-Time Setup