Cisco TelePresence SX20 Panduan Memulai - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Sistem Konferensi Cisco TelePresence SX20. Cisco TelePresence SX20 42 halaman. In-room control on touch 10
Juga untuk Cisco TelePresence SX20: Set Cepat (8 halaman), Panduan Memulai (41 halaman), Panduan Memulai (42 halaman), Panduan Referensi Cepat (2 halaman), Set Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (29 halaman), Panduan Pemecahan Masalah (37 halaman), Panduan Informasi Kepatuhan Peraturan dan Keselamatan (9 halaman), Setup Manual (8 halaman), Panduan Pengguna (38 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (37 halaman), Manual (45 halaman), Manual (45 halaman), Lembar Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (5 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (38 halaman), Panduan Referensi (8 halaman), Panduan Memulai (46 halaman)

Cisco TelePresence Video Systems

Contents

Setting the Administrator Settings

menu password

When starting up the system for the first time the Administrator

Settings menu password is not set.

A warning on the screen of your video system indicates if no

administrator password is set. to remove the warning you

must set an administrator password. if you wish to remove

the warning without setting a password, you can leave the

password field blank, though this is not advisable.

NoTe:

We strongly recommend that you define a password to

protect the Administrator Settings menu, since these settings

affect the behavior of the video conference system.

1. Go to

Home > Settings > Administrator settings > Set

password.

on the remote control, press the # key to toggle between

lower or upper case characters and numbers: abc/ABC/123.

2. enter the menu password. the password you enter is

hidden; each character is replaced with an asterisk (*).

3. Select

Save

to save the changes, or

Cancel

saving.

4. Press

Home

(

)

to exit.

Back to task overview

D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.

Introduction

User interfaces

to leave without

Confirguration

Configuration

Getting Started Guide

Appendices

Contacts