Cisco Firepower 1120 Panduan Pemasangan Perangkat Keras - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Server Cisco Firepower 1120. Cisco Firepower 1120 30 halaman. Connected grid router
Juga untuk Cisco Firepower 1120: Panduan Instalasi (6 halaman), Panduan Memulai Cepat (10 halaman), Manual (6 halaman), Panduan Pemasangan Perangkat Keras (42 halaman), Panduan Penyebaran (8 halaman), Memulai (42 halaman), Panduan Pemasangan Perangkat Keras (42 halaman)

Halaman Cetak
Cisco Firepower 1120 Panduan Pemasangan Perangkat Keras
Overview
9
11

Rear Panel LEDs

The following figure shows the LEDs on the rear panel of the Firepower 1100 series and describes their states.
Figure 6: Firepower 1100 Series Rear Panel LEDs
1
Status LEDs
The locations and meanings of the status
LEDs are described in
Rear Panel LEDs,
on page
7.
SSD LED
Status light for the installed SSD. See
Panel LEDs, on page 7
for more
information.
Network
Status of the network ports.
Link status (L):
• Off—No link, or port is not in use.
• Green—Link established.
• Green, flashing—Link activity.
10
Reset button
A small recessed button that if pressed for
longer than three seconds resets the chassis
to its default state following the next
reboot. Configuration variables are reset
to factory default. However, the flash is
not erased, and no files are removed.
12
SSD bay
Rear
You can replace the SSD if it fails. See
Replace the SSD , on page 25
information.
Network
2
Status of the network ports.
Connection-speed status (S):
• Green, flashing—One flash every three
seconds = 10 Mbps.
• Green, flashing—Two rapid flashes =
100 Mbps.
• Green, flashing—Three rapid flashes =
1000 Mbps.
Cisco Firepower 1100 Series Hardware Installation Guide
Rear Panel LEDs
for more
7