Cisco TelePresenceMCU 5300 Series Memulai - Halaman 6
Jelajahi secara online atau unduh pdf Memulai untuk Server Cisco TelePresenceMCU 5300 Series. Cisco TelePresenceMCU 5300 Series 20 halaman. Multipoint control units
Halaman Cetak
Connecting the MCU
Before you start
IMPORTANT
information at
Step one: Connect power
Connect the power connector on the rear of the unit to the power supply using the
supplied power cable. (There is no On/Off switch.)
Step two: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch.
Only connect to Ethernet Port B if you need to connect the MCU to a
i
second subnet.
Do not connect Ethernet Port A and Ethernet Port B to the same subnet.
!
Failing to configure both sides of the Ethernet connection in the same
!
way can result in packet loss leading to poor audio and video quality.
: Before installing the MCU, you must read the safety
http://www.cisco.com/go/telepresence/safety
Connecting the MCU
.
6