Cisco Firepower 1600 Panduan Pemasangan Perangkat Keras - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Gerbang Cisco Firepower 1600. Cisco Firepower 1600 44 halaman.
Halaman Cetak
Installation Preparation
•
•
•
•
•
•
•
Installation Warnings
Be sure to read the REGULATORY & COMPLIANCE SAFETY INFORMATION document before installing
the Firepower Management Center management appliance.
Caution
Do NOT open the appliance except under direction from TAC.
Take note of the following warnings:
Warning
Statement 1071-Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Statement 1005-Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: USA: 120 V, 15 A (EU: 250 V, 16 A)
Installation Warnings, on page 23
Safety Recommendations, on page 25
Maintain Safety with Electricity, on page 25
Prevent ESD Damage, on page 26
Site Environment, on page 26
Power Supply Considerations, on page 26
Rack Configuration Considerations, on page 27
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
2
C H A P T E R
23