Epson 6110i - PowerLite XGA LCD Projector Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson 6110i - PowerLite XGA LCD Projector. Epson 6110i - PowerLite XGA LCD Projector 17 halaman. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Juga untuk Epson 6110i - PowerLite XGA LCD Projector: Panduan Pengguna (42 halaman), Panduan Pengoperasian (36 halaman), Panduan Pengoperasian (47 halaman), Spesifikasi (2 halaman), Panduan Tambahan (1 halaman), Panduan Pengaturan Cepat (7 halaman), Panduan Pengguna (1 halaman), Daftar Bagian (1 halaman), Pernyataan Kesesuaian (4 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman)

Epson PowerLite 6110i

3. Replace the battery cover. Make sure it clicks into place.

Before you clean the projector case, turn off the projector and

unplug the power cord.

❏ To remove dirt or dust, wipe the outside case with a soft,

dry, lint-free cloth.

❏ To remove stubborn dirt or stains, moisten a soft cloth with

water and a neutral detergent. Then wipe the case.

Caution: Do not use wax, alcohol, benzene, paint thinner, or other

chemical detergents. These can damage the case.

Clean the lens cover glass whenever you notice dirt or dust on

the surface.

❏ Use a canister of compressed air to remove dust.

❏ To remove dirt or smears on the lens, use a commercially

available cloth for cleaning eyeglasses.

Caution: Do not use glass cleaner to clean the lens; this will

damage the lens coating.

Cleaning the Air Filter

Clean the air filter when you see any of the following

messages:

The air filter is clogged. Clean or replace the air

filter.

Check or Replace the air filter

proper ventilation and can cause overheating and damage the

projector.

Note: If you installed the optional smoke filter, follow these same

instructions to clean it.

Follow these steps:

1. Turn off the projector and unplug the power cord.

2. Lift the air filter cover by pulling up the tabs.

3. To clean the filter, Epson recommends using a small

vacuum cleaner designed for computers and other office

equipment. If you don't have one, gently clean the filter

using a very soft brush (such as an artist's paint brush).

You can remove the filter to clean both sides.

Note: If the air filter has been stained by tobacco smoke, it

cannot be cleaned. Replace the filter as described below.

4. When you have finished cleaning the air filter, close the

cover and reset the timer as described on page 13.

5. If the dirt is difficult to remove or a filter is broken, replace

the filter as described in the next section.

12/07

. Dust clogs prevent