Toshiba DIGITAL Series Catatan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Semua dalam Satu Printer Toshiba DIGITAL Series. Toshiba DIGITAL Series 4 halaman. Split type
Juga untuk Toshiba DIGITAL Series: Panduan Pemilik (48 halaman), Panduan Pengguna (45 halaman), Panduan Pengguna (49 halaman), Panduan Pemilik (50 halaman), Panduan Pengguna (48 halaman), Panduan Pemilik (4 halaman), Panduan Pemilik (41 halaman), Panduan Pemilik (22 halaman)

CONNECTOR

INSTALLATION INSTRUCTIONS

Note: Toshiba's 2.5" HDDs are primarily used in notebook devices. Installation

into a notebook varies depending on the system manufacturer. Toshiba's 2.5"

drives that are installed into a desktop PC require a 3.5" installation kit.

1. Determine mounting configuration (can be mounted in either a horizontal or

vertical orientation).

2. Configure drive for system application.

3. Configure the adapter board for the specific system application (if required).

4. Install the I/F cable to the System's 44 pin connector port or adapter board.

Ensure Pin 1 is oriented correctly. (Pin 1 on the cable is usually identified by a

red or blue stripe.)

5. Refer to applicable manuals for software installation instructions.

P/N 480056-F0

08/04

INTERFACE

FIGURE 1 – 2.5" HDD JUMPER LOCATIONS

JUMPER

No Jumper

C-D Jumper

B-D Jumper

A-B Jumper

A-C Jumper

MOUNTING HOLES

FIGURE 2 – MOUNTING HOLE LOCATIONS

2.5" Hard Disk Drive Installation Notes - 9.5mm GAS Series

KEY

PIN 20

P28

DRIVE

Master Drive

Slave Drive

LOW

Master Drive

Slave Drive

HIGH

Slave Drive/

Prohibit

C A

D B

JUMPERS